UNS S31254 ,1.4547 , 254SMO ,X1CrNiMoCu N 20-18-7
|UNS S31254 ,1.4547 , 254SMO ,X1CrNiMoCuN 20-18-7|
|EN symbol||X1CrNiMoCuN 20-18-7|
Z1 CNDU 20.18.06AZ
UNS S31254 is an austenitic grade in which the additions of chromium, molybdenum and nitrogen give
high resistance to pitting in sea water. This alloy has a mean Pitting Resistance Equivalent Number (‚PREN‘
= Cr+3.3Mo+16N) of 43.8. Tests indicate high resistance to crevice-corrosion attack in seawater and to
stress corrosion cracking in hot concentrated sodium chloride.Compared with CrNiMo 17 12 2.5 steels, it
shows superior corrosion resistance in many acids at similar concentrations and its yield strength is approximately
50% higher. Good weldability using Ni-Cr-Mo consumables. Quench annealing and short periods
within the 600-1000°C range avoids the possiblen development of deleterious sigma phase, which may
embrittle and impair corrosion resistance.
The steel is mainly characterized by the following properties:
*Excellent resistance to pitting and crevice corrosion
*High resistance to general corrosion
*High resistance to stress corrosion cracking
*Higher strength than conventional austenitic stainless steels
Chemical composition (%)
|Grade||Tensile Strength||Yield Strength 0.2%||Elongation -% in 50 mm (min.)||Hardness||Hardness|
|ksi (min.)||Offset ksi (min.)||(Brinell) MAX||(Rockwell B) MAX|
Convert ksi to Mpa Formula: ksi/0.1450377
The tubes are delivered in heat treated condition. If additional heat treatment is needed due to further processing the following is recommended.
1150–1200°C (2100–2190°F), quenching in water. Thin-walled tubes min. 1130°C (2060°F), quenching in air/water.
|Welding filler for welded pipe & tube|
*The weldability of 254 SMO is good. Welding should be undertaken without preheating, and if correctly performed there will be no need for any subsequent heat treatment. Suitable methods of fusion welding are manual metal-arc welding with covered electrodes and gas-shielded arc welding, mainly by means of the TIG and MIG methods.
In common with all austenitic stainless steels, 254 SMO has low thermal conductivity and high thermal expansion. For this reason, welding should be carefully planned in advance so that distortion of the welded joint can be minimized. If, despite these precautions, it is believed that residual stresses may impair the function of the weldment, it is recommended that the entire structure be solution annealed. See under Heat treatment.
|Main fields of application(depending on the specific conditions of use)|
254 SMO is used in the following applications:
-Equipment for handling of seawater, such as, seawater cooling, cooling water pipes, ballast water systems, firefighting systems etc.